ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
OPERATION INSTRUCTIONS
Warning: Before using your mitre
saw be sure to read the instruction
manual carefully.
Operating instructions
1. Know your mitre saw
Read and understand the Operator’s Manual and
and limitations as well as the potential hazards
accidental contact with moving parts, do not lay
out, assemble or set up work on the mitre saw.
2. Electrical connection
Your mitre saw has a precision-built electric
Do not operate on direct current (DC). This large
voltage drop will cause a loss of power that will
overheat the motor. If your mitre saw does not
operate when plugged into an socket, have a
professional electrician check the power supply.
Warning: Avoid accidental starting.
Make sure the switch is in the
OFF position before plugging the mitre
saw into a power socket.
3. Body and Hand position
Warning: Never place hands near the
cutting area. Proper positioning of
your body and hands when operating the
mitre saw will make cutting easier and safer.
Keep children away. Keep all visitors at a
safe distance from the mitre saw. Make sure
bystanders are clear of the saw and workpiece.
safer at its designed rate.
Starting a cut:
the blade – out of the “no-hands zone” (1).
(See Fig 27)
prevent movement toward the blade.
Fig 27
No-Hands Zone
1
To Next Page
Loading...
