Erbauer ERB238MSW - Adjustment Instructions; Bevel Stop Adjustment; 90 Degrees (0 Degrees) Bevel Adjustment

ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
ADJUSTMENT INSTRUCTIONS
1. Bevel stop adjustment
Warning: 
accidental start, make sure the switch is
in the OFF position and the plug is not connected
to the power source socket.
2. 90° (0°) Bevel adjustment
1) Loosen bevel lock handle (1) and rotate the
cutting arm completely to the right until it stops
against the vertical stop. Tighten the bevel lock
handle.

table with the ruler against the table and the

°°
table (5), loosen the bevel lock handle (1), tilt the
cutting head to the left, loosen the locknut (4) on the


out to increase or decrease the bevel angle.
°
°) bevel and recheck for alignment.

is needed.
6) Tighten bevel lock handle (1) and locknut (4)
when alignment is achieved.


5
2
4
3
1