4. Step
The strap lifter comes up
automatically when the
reversing sledge moves back
into the strapping system.
Now you have to loose the
strap tension of your left hand;
otherwise the strap lifter will
not be able to come up.
The strap lifter lifts the second
end of the strap up to working
height so you can grasp it
without bending down.
Only keep the joystick pushed
until the strap lifter is fully in its
upper position.
The strap lifter automatically
moves down again after 2
seconds. (The strap lifter will
not go down automatically after
2 seconds if the upper position
has not been reached
successfully)
Fig. 56
- 45 -
Attention!
You have to hold the strap loosely in your hand when the
strap lifter comes up.
The strapping system automatically switches off to prevent
damages if you do not release the strap once the strap lifter
comes up. The strap lifter can be raised up again by
repeatedly pushing the joystick in the “move in direction”.
To Next Page
Loading...
