EasyManua.ls Logo

Erhardt+Leimer OL 80 - Camera start-up response

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BEA--220265-EN-04 BPage27
CCDarraycameraOptoLineOL80..
9. Camera start-up
response
Example 2 , see illustration at the bottom of page 26:
The web is to be guided by the right web edge. For this purpose, the
set value of measured value 1 must be stored.
Beforeguiding,thewebshouldbeplacedinthecamerameasur-
ingrangesothattherightwebedgeispositionedatthesetpoint.
Storethesetpositionofmeasuredvalue1(rightwebedge).To
doso,rstpresstheSETUPkeyonE+LcommanddeviceDO
1...thenthekeywhichyouusedtoselecttherightsensoronyour
commanddevice, or .Therightwebedgesetpositionis
nowstoredinparameter13.Iftherightwebedgedeviatesfrom
thesetpoint,theguidercorrectsthepositionoftheweb.
Thestoredsetpositionisretaineduntilanewvalueisstored.
8.1.2 Specify the set position value via the setup editor
Themeasuredvaluesetpositionmayalsobespeciedviathesetup
editor.
Beforeguiding,positionthewebinthecamerameasuringrange
sothatthemeasuredvalueislocatedatthesetpoint.Seeexam-
ple8.1.1.
Callupthesetupeditor.
Entera4(deneguidingcriterion)inparameter3ofthecamera,
thenchangeparameter.Themeasuredvaluesetpositionisnow
storedinparameter13.
Thestoredsetpositionisretaineduntilanewvalueisstored.
8.1.3 Retaining the set position value
Onapplicationsinwhichthesetpositionvaluealwaysremainscon-
stant,thestoringofnewpositionvaluesmaybeinhibited.
Entera0inparameter42,storesetpositionvalue(nophotoop-
erationpossible).
NeithercommanddeviceDO1...norparameter3maybeusedto
storeanewsetpositionvalue.
Thecameranotesallthesettingswhenthevoltageisswitchedoff.
Whenthepowerisswitchedonagain,thecongurationpreviously
setisusedforoperation,i.e.theoperatingmodes,thereferencepo-
sitionsdeterminedduringwebguidingandthemessagestobesent
totheCANbusareretained.