Chapter 2
2.7.7 AUDIO/AUDIO OUT Connector
All units provide a pair of connectors supplying two
stereo channels. Each carries a single channel stereo
pair in both analogue and balanced digital form.
Table 2.8 AUDIO/AUDIO OUT Connectors
AUDIO/AUDIO OUT
Item Specification
Connector type 9-way, D-type, male
Connector designations AUDIO OUT 1
AUDIO OUT 2
AUDIO 3 (RX8200 only)
AUDIO 4 (RX8200 only)
Pin-outs
Pin 1 – Digital audio +
Pin 2 – Ground
Pin 3 – Left +
Pin 4 – Right +
Pin 5 – Ground
Pin 6 – Digital audio –
Pin 7 – Ground
Pin 8 – Left –
Pin 9 – Right –
Nominal output impedance
50 Ω
Maximum data rate 3.072 Mbps
Analogue Output level
+20 dBm nominal clipping
level. Selectable in range 12
to +24 dBm.
Load impedance
≥600 Ω balanced
2.7.8 ETHERNET/CONTROL Connector
All units provide two Ethernet remote control interfaces
for Web Browser Control.
Table 2.9 ETHERNET/CONTROL Connectors
Item Specification
Connector type RJ-45 (100BaseT)
Connector designation ETHERNET 1 or CONTROL 1
ETHERNET 2 or CONTROL 2
Pin-outs
(Unused pins not
connected)
Pin 1 – Tx Out (+)
Pin 2 – Tx Out (-)
Pin 3 – Rx In (+)
Pin 6 – Rx In (-)
ETHERNET/CONTROL
EN/LZT 790 0005 R1A
2-13
To Next Page
Loading...
