18
NOTE: when the logic inputs are selected, the WAIT function can
be enabled/disabled by logic input 2 only.
2.3.3 NONE
When NONE is selected no option will be used and the instrument
goes automatically to the next configuration step
After option selection and its parameter setting, the display will
show the following:
Select the desired default engineering unit.
Depressing the FUNC push-button.
The display will show the following:
Select the derired standard for TC and RTD measure and genera-
tion.
Depressing the FUNC push-button.
DEFAULT ENG.UNIT
°C °F
The configuration procedure is completed and the instrument will
memorize the new configuration parameters and goes automati-
cally to the STAND BY mode.
NOTE: It is possible to stop the configuration procedure in any
moment by pushing SET UP/INS pushbutton. The instrument will
memorize the new setting followed by FUNC pushbutton pressure
and it will use the old values for all the other parameters.
TEMP. STANDARD
IPTS-68 ITS-90
M20-e-2.p65 7/9/01, 2:40 PM18
To Next Page
Loading...
