56
3.12 - OHM SIMULATION
2-WIRE CONNECTION FOR OHM SIMULATION
NOTE: for all ohm simulation, the measuring current must be
higher than 100 mA, lower than 2 mA and having the polarity shown
in the figure; otherwise the instrument could show an error
message (see chapter ERROR MESSAGES).
3-WIRE CONNECTION FOR OHM SIMULATION
W
MEASURING
DEVICE
+
-
From 15 to 500 OHM
W
MEASURING
DEVICE
+
-
From 15 to 500 OHM
M20-e-3.p65 7/9/01, 2:41 PM56
To Next Page
Loading...
