ESAB Rogue ES 200i Pro User Manual (English)

Other manuals for ESAB Rogue ES 200i Pro

Questions and Answers:

G
Gary WalkerAug 9, 2025
How to troubleshoot MMA welding problems with my ESAB Rogue ES 200i Pro?
- G
  Gerald ColeAug 9, 2025
  If you're experiencing issues with MMA welding on your ESAB Welding System, make sure that the welding process is set for MMA. Also, verify that the welding and return cables are correctly connected to the power source. Ensure the return clamp has good contact with the workpiece. Check that you're using the correct electrodes and polarity (refer to the electrode packaging for polarity). Confirm the correct welding current (A) is set, and adjust Arc Force and Hot start as needed.
A
Angela BerryAug 20, 2025
How to fix TIG welding problems on my ESAB Rogue ES 200i Pro Welding System?
- K
  Katherine LynchAug 20, 2025
  If you're having TIG welding problems with your ESAB Welding System, ensure the welding process is set for Live TIG as necessary. Confirm that the TIG torch and return cables are correctly connected to the power source. Ensure the return clamp has good contact with the workpiece and that the TIG torch lead is connected to the negative welding terminal. Also, be sure you're using the correct shielding gas, gas flow, welding current, filler rod placement, electrode diameter, and welding mode on the power source. Finally, check that the gas valve on the TIG torch is ON.
A
Allen OrtizAug 29, 2025
What to do if my ESAB Rogue ES 200i Pro has no arc?
- B
  bowmanjessicaAug 29, 2025
  If your ESAB Welding System has no arc, start by checking that the electrical power supply switch is turned on and that the display is on, verifying the power source has power. Also, check that the setting panel displays correct values. Ensure the welding and return cables are correctly connected and inspect the electrical power supply fuses.

ESAB Rogue ES 200i Pro Specifications

General

Duty Cycle	60% at 200 A
Dimensions	403 x 153 x 264 mm
Input Current	32 A
Protection Class	IP23S
Input Frequency	50/60 Hz
Power Factor	0.99
Efficiency	85%
Process Types	MMA, TIG
Input Phase	1 phase
Welding Processes	Stick (MMA), TIG