ESAB WARRIOR EDGE 500 - USB Fault; Software Runtime Fault; External Stop

8  EVENT CODES
0463 772 001
- 33 -
© ESAB AB 2023
1. Check gas input pressure.
2. Check the gas hoses, gas pressure regulator and connectors and acknowledge.
3. Select the appropriate setting of gas flow in control panel.
x33
USB fault
This event code is displayed due to one of the following:
• 033 - USB high current.
• 033 - USB read/write error.
1. Make sure that the USB is in good working condition and configured properly.
2. Contact service technician.
x35
Software runtime fault
This event code is displayed due to one of the following:
• 035 - Message allocation error.
• 035 - Driver message allocation error.
• 035 - Event queue overflow.
• 035 - Failed to start microservices.
1. Restart the system.
2. Contact service technician.
x36
External stop
This event code is displayed due to one of the following:
• 736 - Fieldbus quickstop.
• 736 - Fieldbus superquickstop.
1. Acknowledge by pressing any buttons on the control panel.
2. Restart.