8.Appendix：
Auto Provision
1.Bulid TFTP/HTTP/HTTPS/FTP Server
1.1 The Auto Provision Working principle
1. Bulid the FTP/HTTP/HTTPS/FTP Server
2. Place the Auto Provision related file(configure file/software/kernel) in server
3. The phone according to the the server URL and download the file to update the
phone data or upgrade software/kernel
4. You can do 3 way to start Auto Provision:
* Booting Checked: Auto Provision when the phone booting after reboot.
* Auto Provision Now manually.
* timing Auto Provision
1.2 Bulid TFTP/HTTP/HTTPS/FTP Server
The auto provision Server don’t distinguish the model of server,it only need the
server can support TFTP/HTTP/HTTPS/FTP protocol.
If you already build TFTP/HTTP/HTTPS/FTP Server,so you only need place some
related auto provision file in server and config the parameters in auto provision web
page.
If you don’t have TFTP/HTTP/HTTPS/FTP Server,we can suggest you to
download the server in Internet by yourself.
Tftp server:cisco tftp or tftpdwin
Ftp server: Serv-U Server
Http server:hfs server
If you finished build your TFTP/HTTP/HTTPS/FTP Server,you can follow do
this:place some related auto provision file in server and config the parameters in auto
provision web page.
2. Place the configure file/software/kernel in Server
When the software or kernel auto-provision is enabled and want to run, IP Phone
will check the software and kernel version at first, so we need make some
pre-configuration on the provisioning server.
To Next Page
Loading...
