Need help?Do you have a question about the eschmann T20-a and is the answer not in the manual?
Lists related publications for the service manual.
Importance of instructions for use, cleaning, and disinfection.
Emphasizes following the service schedule and correct torque settings.
Identifies main parts and describes the 'Service Position' procedure.
Warning about critically low battery levels and proper charging procedures.
Nominal weights and major dimensions of the standard table components.
Maximum table movements, limitations, and patient weight capacity.
Details antistatic requirements, batteries, chargers, and fuses.
Guidance on using the table with other equipment and compliance standards.
Specifies operating, transport, and storage environmental conditions.
Details the power supply and overview of control electronics with PCAs.
Details the four and three actuator PCAs and their functions.
Overview of infrared and corded handset versions and their operation.
Safety precautions for 'Service Position' and lifting heavy assemblies.
Safety for working with mains voltage, gas springs, hot parts, and contamination.
Safety regarding connecting leads and handling leaking batteries.
Replacing power supply and basic table fault finding procedures.
Identifying electronic faults, connector block issues, and fuse locations.
Detailed checks for base and column components, covers, and wiring.
Checks for trunk, head, leg sections, covers, and related components.
Ensures electrical safety checks are performed as per Appendix 4.
General notes and safety for part replacement, parts list reference.
Procedures for accessing components via base and column covers.
Steps for removing and replacing base covers.
Methods for gaining access to different parts of the column.
Procedures for removing/refitting telescopic covers and bellows.
Lists base components and procedures for replacing batteries and pedal dampers.
Procedures for replacing front wheels, castor assemblies, and brake pads.
Procedures for replacing castor pillar bushes, pedal spindle bushes, lifting roller assembly, etc.
Procedures for replacing pedal catch block and anti-skid pads.
Procedures for replacing Trendelenburg, Tilt actuators, and their motors.
Detailed procedure for replacing the telescopic column assembly.
Procedures for replacing actuator motors, bushes, and bearing pads.
Procedures for replacing guide pins, gas springs, and top covers.
Warning about high-pressure gas in springs and disposal procedures.
Procedures for replacing gas spring release parts and X-ray translucent tops.
Procedures for replacing traverse motors and drive belts.
Procedures for replacing break motors and break gearboxes.
Procedures for replacing side rails, top covers, and push button components.
Procedure for replacing traverse rod bearings.
Lists electrical components that may need replacement.
Procedures for replacing actuator PCAs and the power supply assembly.
Procedures for replacing traverse, break, tilt, Trendelenburg, and height motors/looms.
Procedures for replacing telescopic column assembly and potentiometer looms.
Procedures for replacing traverse motor loom, connector blocks, panel looms, and energy chain.
Procedures for replacing gearbox loom, batteries, fuses, and changing infrared codes.
Testing batteries, battery charger, corded, and infrared handsets.
Testing footswitch, standby panel, head/leg sections, and base pedals.
Performing a cycle of movements to test all table functions.
General notes on accessories servicing and cleaning.
Chart for converting Nm to lb in/lb ft for imperial torque tools.
Guidance on reprogramming, reconfiguring, or recalibrating table PCAs.
Schematic diagram of the T20-a trunk section wiring.
Schematic diagram of the T20-a pedestal section wiring.
Schematic diagram of the T20-a base section wiring.
Procedure for Portable Appliance Testing (PAT).
Testing antistatic path resistance and enclosure leakage current.
General| Brand | eschmann |
|---|---|
| Model | T20-a |
| Category | Medical Equipment |
| Language | English |
To Next Page
