eschmann T20-a - Cycle of Movements Test; Accessories Servicing and Cleaning

P48/54 T-SM47j
6.7.8 Base pedals
Operate each base pedal to ensure it functions correctly,
that motion is correctly damped by the spring damper and
that the return spring is in situ and working correctly.
6.7.9 Cycle of movements
CAUTION
During the following cycle of movements
(designed to test all table functions) note that
extreme care must be taken not to damage the
table when powering the table to maximum
movements (e.g. with table at minimum height
maximum Trendelenburg cannot be achieved
and with leg section fully lowered minimum
height cannot be achieved).
1 Press the autolevel button until the table top has
returned to level.
2 Operate the table into maximum tilt in both directions
and confirm the amount of movement agrees with
that in the technical data section (using a digital
protractor). Return the table top to level with the auto
level button.
3 See caution above. Operate the table into maximum
Trendelenburg in both directions and confirm the
amount of movement agrees with that in the
technical data section (using a digital protractor).
Return the table top to level with the auto level button.
4 Operate the table to maximum traverse in both
directions and confirm the amount of movement
agrees with that in the technical data section.
5 See caution above. Operate the table to maximum
and minimum height and confirm the heights agree
with those in the technical data section.
6 See caution above. Operate the table into maximum
break in both directions and confirm the amount of
movement agrees with those in the technical data
section (using a digital protractor). Return the table
top to level with the auto level button.
7 See caution above. Operate the table into maximum
Flexion and maximum Extension and return the table
top to level with the auto level button.
8 Lower both head and leg section fully, ensure the
table is braked and switch it ‘off’. Leave batteries on
charge if they are not fully charged.
6.8 ACCESSORIES
Most accessories are basic in nature and part replacement
is not usually required. Servicing is covered for similar items
in the preceding sections (e.g. guide pin replacement).
Cleaning and disinfection is the same as for the main table
and is covered in the Instructions for use supplied with the
product.