Escort 3136A - Page 86

82
CONFigure[:SCALar]:OFFDual
Description:
Turn off the secondary display.
Note: After this command, the secondary display still indicates signal source as the
frequency measurement is on primary display.
CONFigure[:SCALar]:OFFRecord
Description:
Exit the dynamic recording mode (MAX / MIN).
CONFigure[:SCALar]:RANGe:AUTO <Boolean> [ ,@1]
Description:
Enable or disable the auto range mode.
Parameter: <Boolean> (ON, 1; OFF, 0)
CONFigure[:SCALar]:RANGe:AUTO? [ [ ,@1] | ,@2 ]
Description:
Query the auto-ranging status.
Response: 1 (Enable) or 0 (Disable).
CONFigure[:SCALar]:RANGe:DIRection < UP | DOWN > [ [ ,@1] | ,@2 ]
Description:
Change measuring range, to increase or decrease the range one step.
Parameter: < UP >, increases one step; < DOWN >, decreases one step.
CONFigure]
[:SCALar]
:RANGe? [ [ ,@1] | ,@2 ]
Description: Query the measuring range. Use @1 for the primary display, and @2 for the
secondary display.
Response:
Return the range value as Table 7-4.
Example:
CONF:RANG? ; Query the measuring range of primary display.
CONF:RANG? ,@2 ; Query the measuring range of secondary display.