88
Command Parameter Std/New Explanation
CALCulate Std Set the calculation function.
:DBM
New Set dBm reference impedance
:IMPedance
<reference> New
[:STAT]
<Boolean> New
:LIMit
Std Set and query the comparator.
:FAIL?
Std
:LOWer[:DATA]
<number value> Std
[:STAT]
<Boolean> New
:UPPer[:DATA]
<number value> Std
:RECord
New Set the dynamic recording mode.
:MAXimum
New
:MINimum
New
:MINMAX
New
:OFF
New Turn off recording mode
:RELative
New
[:STAT]
<Boolean> New
:PERcentage
New
[:STAT]
<Boolean> New
:MODE?
New Query the calculation function.
INITiate[IMMediate] Std Reset meter without changing setup
:CONTinuous
<Boolean> Std
Set the meter at free run or data hold operation
mode.
:CONTinuous?
New Query the operation mode.
TRIGger Std
Trigger function
:SOURce
<BUS|IMM> Std Select a trigger source.
:SOURce?
Std Query the trigger source type.
MEASure? Std
Trigger and get measuring value.
READ? [[,@1]|,@2] Std
Read the display value.
READ?? New
Read the both display values.
SYSTem Std Subsystem
:ERRor?
Std
Read the error message.
:VERSion?
Std
Return the firmware version.
Note:
“Std” commands means defined in SCPI standard and “New” commands are not
defined.
To Next Page
Loading...