ESI-50L Administrator’s Manual Function 2: CO lines
B.1
Function 1: System parameters
Function 13: Administrator password
This function will display the existing password and prompt for entry of a new password. The password can be
2–8 digits long, followed by #. Only those functions listed in this Administrator’s Manual can be
programmed via the Administrator password. The default Administrator password is 4 5 6.
Note: Be sure to write down the new password and store it in a safe place.
Accessing user station programming
Should a user forget his password or if an employee leaves the organization, this feature allows the
Administrator to enter a user's station programming and operate within it as if he were the user. From the
user’s station, enter the Administrator password when the system prompts for the user password.
Example: From station 105, entering 7 8 9 # or 4 5 6 # instead of the user password (1 0 5 #) will enter the station’s
user programming. (Default passwords shown for this example).
Function 14: System clock
Function 141: Set time/date
1. Enter a new time in a twelve-hour format.
Example: Enter 1 2 3 3 for 12:33, or 3 1 5 for 3:15 (note that you need no leading zero for the time).
2. Select AM or PM by pressing a scroll key (either
or
).
3. Enter a new date in an eight-digit format, including leading zeroes.
Example: Enter 0 7 0 4 2 0 0 8 for July 4, 2008 (note that leading zeroes are required here, unlike in Step 1).
4. Press # to finish the entry.
Note: A built-in battery maintains the correct time and date, even in the event of a power loss.
(Continued)
To Next Page
Loading...
