1.2
Performance
Description
The performance view shows the actual torque, power, air mass and turbo boost. Since it is rather
dangerous to look at the display while performing a full pedal acceleration, the values will reset to
zero when accelerator pedal is pressed more than 80% and directly after it will show the maximum
read value until the accelerator pedal is below 30% for more than 10 seconds, then it will again show
the actual value. This means it is possible to perform acceleration and then afterwards look at the
maximum values during that acceleration.
Units
• Same units as in Torque/Power/Air mass/Boost display views.
User Inputs
• N/A
To Next Page
Loading...