1.2
Different view when eSID is going passive (ICM: ALL)
ICM is still reading the SIDC at all times, even when eSID is active and the ICM cannot show anything
on the SID. So when returning to ICM it might be in a different view then when switched to eSID.
It might also have detected a long press on INFO as a valid command to change Speed limit for
instance.
It has been found that ICM can fail to print out all the data on the display when eSID is going from
Active to Passive, but it is usually corrected by turning the SIDC. This is erratic fault handling in the
ICM and only a consequence when using eSID, not eSID’s fault.
Note! Avoid pressing “Customize” when eSID is active as one might change the ICM Settings without
knowing/seeing it.
To Previous Page
Loading...