5
SAFETY INFORMATION
GENERAL INFORMATION
This water heater’s design is certified by UL and listed in accordance with UL 174.
This water heater must be installed in accordance with local codes. In the absence of local codes, install this
water heater in accordance with the N.E.C. Reference Book (latest edition). The warranty for this water
heater is in eect only when the water heater is installed, adjusted, and operated in accordance with these
Installation and Operating Instructions. The manufacturer will not be held liable for damage resulting from
alteration and/or failure to comply with these instructions. This water heater has been designed and certified
for the purpose of heating potable water. The installation and use of this water heater for any purpose other
than the heating of potable water, may cause damage to the water heater and create a hazardous condition
and nullify the warranty. Do not use this appliance if any part has been submerged in water. The plumbing
professional responsible for the installation of this water heater should be contacted to inspect the appliance
and to replace any part of the control system, including thermostat, which has been submerged in water.
Make sure that the rating plate on the water heater is referenced for certainty that the correct voltage is
being supplied to the water heater.
IMPORTANT: Before proceeding, please inspect the water heater and its components for possible damage.
DO NOT install any damaged components. If damage is evident, please contact the supplier where the water
heater was purchased or the manufacturer listed on the rating plate for replacement parts.
FOR YOUR RECORDS
Write the model and serial numbers here:
The model and serial number can be found on the
identification label, located on top of the water heater.
Model #:
Serial #:
Installing Company:
Installing Technician:
Contact Phone Number:
Staple sales receipt here.
Proof of the original purchase date is needed to
obtain service under the warranty.
To Next Page
Loading...