Model Eye: 1
With a contact lens holder
Diopter value is indicated on the sticker.
Power cord: 1
(2.5m)
Printer paper: 3
(Width: 58mm)
[2 included and 1 installed in the unit]
Fuse: 2
(T2A L 250V)
Chinrest liner: 1
(1,000 sheets)
Chinrest liner pin: 2
Dust cover: 1
Operation manual: 1
Name Model No. Length
Power cord KP4819YKS31A or equivalent 2.5m
Use only the accessories specified by us.
Use of the accessory (power cord) other than specified below may adversely affect other
instruments and/or cause malfunction of this device.
Extra care should be taken for storage of a model eye.
Do not store it at where it is dusty or high-temperature and humidity.
Avoid direct sunlight, high-temperature and humidity when storing the printer paper because it is
a thermal paper.
To Next Page
Loading...
