Estun ProNet Plus Series - Page 52

ProNet Plus Series AC Servo User's Manual
- 50 -
Aprox.2m
Noise
filter
1
4
2
3
Clamp
Core
Core
Core
Core
Core
Core
Core
Aprox.5m
Host controller
Clamp
Clamp
Brake
Servo-
motor
Encoder
Servo Drive
PE
PE
U,V,W
Brake power
supply
L1C,L2C
L1,L2,L3
CN2
CN1
Power Supply
Three-phase 200VAC
Three-phase 400VAC
Ground/Shield Box
Symbol
Cable Name
Specifications
①
I/O signal cable
Shield cable
②
Servomotor cable
Shield cable
③
Encoder cable
Shield cable
④
AC line cable
Shield cable
Notes: The example above shows three-phase 200VAC servo drive connection.
(2) Cable Core and Cable Clamp
(a) Attaching the Ferrite Core
The diagram shows two turns in the cable.
The table shows the cable and the position where the ferrite core is attached.
Cable
Ferrite core
(b) Recommended Ferrite-core
Cable Name
Ferrite Core Model
Manufacturer
I/O signals cable
ESD-SR-25
TOKIN
Encoder cable
Motor
cable
400W or less
750W or less
PC40T96 × 20 × 70
TDK
Cable Name
Mounting Position of the Core
I/O signals cable
Near the host controller and servodrive.
Motor cable
Near the servodrive and servomotor.
Encoder cable
Near the servodrive and servomotor.