Need help?Do you have a question about the Estun ProNet-30D and is the answer not in the manual?
General| Rated Power | 3.0 kW |
|---|---|
| Control Modes | Position, Speed, Torque |
| Feedback | Incremental encoder, Absolute encoder |
| Communication Interface | RS485, CANopen |
| Protection Features | Overcurrent, Overvoltage, Overtemperature |
| Supply Voltage | 3-phase AC 200V-240V |
| Input Voltage | 3-phase AC 200V-240V |
Guidelines for installing the servomotor, including storage, site selection, alignment, and orientation.
Instructions for base-mounting the servo drive, covering storage, site conditions, orientation, and mounting methods.
Details on connecting main circuit terminals for servo drives, including voltage and functions.
Explanation of I/O signal connections, names, functions, and terminal layouts for servo drives.
Procedures and diagrams for connecting encoders (CN2) to the servo drive.
Step-by-step guide for performing trial operations of the servomotor, with or without load.
Detailed guide for operating the servo drive using analog voltage for speed control.
Setup and operation procedures for position control using pulse trains and host controller commands.
Configuration and operation guidelines for torque control using analog voltage reference.
Methods for selecting and operating the servo drive using internally set speeds via input signals.
Procedure for automatically tuning servo gains based on load rigidity and inertia.
Detailed guide on using utility functions via the panel operator for adjustments and diagnostics.
To Next Page
