Estun ProNet-30D - Chapter 1; Checking Products and Parts Names; Checking Products on Delivery; Servomotor

ProNet Plus Series AC Servo User's Manual
- 7 -
Chapter 1
Checking Products and Parts Names
1.1 Checking Products on Delivery
If any of the above items are faulty or incorrect, contact your ESTUN representative or the dealer from whom you
purchased the products.
1.1.1 Servomotor
 Servomotor Model Designation
EMJ– 08 A F B 2 4
ESTUN Servomotor
【1+2】
【3】
【4】
【5】
【6】
【7】
EMJ Model
【1+2】Rated Output
【4】Encoder
【7】Option
Code
Spec.
Code
Spec.
Code
Spec.
A5
0.05 kW
F
20 bit incremental encoder: 1048576P/R
1
Without oil seal and brake
01
0.1 kW
S
17 bit absolute encoder: 131072P/R
2
With oil seal, Without brake
02
0.2kW
3
Without oil seal, With brake
04
0.4kW
【5】Designing Sequence
4
With oil seal and brake
08
0.75kW
Code
Spec.
10
1.0kW
A,B,D,H,M
Designing sequence
【3】Voltage
【6】Shaft End
Code
Spec.
Code
Spec.
A
200VAC
2
Straight with key and tap
Check Items
Comments
Are the delivered products theones that
were ordered?
Check the model numbers marked on the nameplate on the
servomotor and servo drive.
Is there any damage?
Check the overall appearance, and check for damage or scratches
that may have occurred during shipping.
Does the servomotor shaft rotatesmoothly?
If the servomotor shaft can be easily rotated by hand, then the motor
is working normally. However, if a brake is installed on the
servomotor, then it cannot be turned by hand.