What to do if eta plus ELC X Controller displays 'Measurement' error?
If your eta plus Controller shows a 'Measurement' error, it indicates problems with the internal measurement circuits. Check for a short in the lamp circuit.
Why is my eta plus Controller showing a 'Temp high' error?
A 'Temp high' error on your eta plus Controller indicates that the ambient or internal temperature is too high. Verify the ambient temperature and check the cabinet fans for proper airflow direction. Consider changing the filter mats.
How to fix Mains volt error on eta plus ELC X?
If you're seeing a 'Mains volt' error on your eta plus Controller, it means the input voltage measurement has detected mains voltage drops or fluctuations. You should check the connections and the mains voltage.
What causes Earthfault on eta plus ELC X Controller and how to resolve it?
An 'Earthfault' error on your eta plus Controller means the insulation resistance between the lamp circuitry and earth is lower than 200 kOhm. Inspect the lamp wiring and insulation resistance.
What does 'Over volt' mean on eta plus ELC X, and how can I fix it?
An 'Over volt.' error on the eta plus Controller indicates that a short peak overvoltage on the lamp exceeds the nominal ignition voltage during ignition or operation. This might be due to an internal problem with the ELC or damaged cables in the lamp circuitry. Check the lamp wiring for insulation defects.
What to do if eta plus ELC X Controller shows 'Lamp v.hi' error?
If your eta plus Controller displays a 'Lamp v.hi' error, it means the lamp voltage exceeds a threshold critical for the ELC. This usually indicates that the lamp type is incorrect. Verify the lamp type and lamp connectors/sockets, and consider switching the lamp.
What does 'CanIntern' error mean on eta plus ELC X?
A 'CanIntern' error on your eta plus Controller indicates interference in modul-internal communication. Check the internal wiring.
What does 'PLow' mean on eta plus Controller and how to fix it?
A 'PLow' error on your eta plus Controller means the lamp extinguishes, possibly due to cooling being too strong or a lamp defect. Reduce cooling or replace the lamp. Also, check the lamp wiring.
What does 'Internal' error mean on eta plus ELC X Controller and how to resolve it?
An 'Internal' error on your eta plus Controller indicates problems with internal communication between controllers or a failed “self-check” of the controllers. Try switching off and on the 24V supply.
What causes a 'Bus error' on eta plus Controller?
A 'Bus error' on the eta plus Controller means the field bus connection failed during lamp operation. Inspect the bus termination and connector contact.
Provides essential safety guidelines for installation and operation.
Defines the intended use and limitations of the ELC.
Details all electrical connection points, including power, control, and bus interfaces.
Covers setting up the ELC, including BUS addresses and parameters.
Details switching the lamp on, dimming, and switching off.
Covers error messages, display indicators, and reset procedures.
General| Brand | eta plus |
|---|---|
| Model | ELC X Series |
| Category | Controller |
| Language | English |
To Next Page