L
Luke RojasSep 3, 2025
How to fix the eta plus ELC X when the display is off?
- KkennedygeorgeSep 3, 2025
If the display of your eta plus Controller is off, check the 24V supply and try switching the controller off and on again.
To Next PageTo Next PageHow to fix the eta plus ELC X when the display is off?
If the display of your eta plus Controller is off, check the 24V supply and try switching the controller off and on again.
Why am I getting a 'DC Link' error on my eta plus ELC X Controller?
A 'DC Link' error indicates that the internal DC link voltage is low due to low mains voltage, blown internal fuses, or other defective parts inside the ELC. You should check the fuses and mains voltage, and consider the charge time.
How to troubleshoot 'Over curr.' error on eta plus Controller?
An 'Over curr.' error on your eta plus Controller signifies an internal overcurrent. Check for a short in the lamp circuit.
What to do if eta plus ELC X Controller shows 'Lamp v.hi' error?
If your eta plus Controller displays a 'Lamp v.hi' error, it means the lamp voltage exceeds a threshold critical for the ELC. This usually indicates that the lamp type is incorrect. Verify the lamp type and lamp connectors/sockets, and consider switching the lamp.
What does 'Over volt' mean on eta plus ELC X, and how can I fix it?
An 'Over volt.' error on the eta plus Controller indicates that a short peak overvoltage on the lamp exceeds the nominal ignition voltage during ignition or operation. This might be due to an internal problem with the ELC or damaged cables in the lamp circuitry. Check the lamp wiring for insulation defects.
What causes Earthfault on eta plus ELC X Controller and how to resolve it?
An 'Earthfault' error on your eta plus Controller means the insulation resistance between the lamp circuitry and earth is lower than 200 kOhm. Inspect the lamp wiring and insulation resistance.
How to fix Mains volt error on eta plus ELC X?
If you're seeing a 'Mains volt' error on your eta plus Controller, it means the input voltage measurement has detected mains voltage drops or fluctuations. You should check the connections and the mains voltage.
Why is my eta plus Controller showing a 'Temp high' error?
A 'Temp high' error on your eta plus Controller indicates that the ambient or internal temperature is too high. Verify the ambient temperature and check the cabinet fans for proper airflow direction. Consider changing the filter mats.
General| Brand | eta plus |
|---|---|
| Model | ELC X Series |
| Category | Controller |
| Language | English |
Provides essential safety guidelines for installation and operation.
Defines the intended use and limitations of the ELC.
Details all electrical connection points, including power, control, and bus interfaces.
Covers setting up the ELC, including BUS addresses and parameters.
Details switching the lamp on, dimming, and switching off.
Covers error messages, display indicators, and reset procedures.