eta plus ELC X Series - ELC X24, X24 B, X24 I, X24 F

6 Technical Data page 71
ELC X-Series-V1.5-06.18-GB subject to technical alterations
6.6 ELC X24, X24B, X24i, X24F
Output power characteristics
Type
ELC X24-210
ELC X24F-210
ELC X24B-210
ELC X24i-210
Power factor
typ. > 97%
Power efficiency
typ. > 94%
Nominal power range
4800 W – 24000 W
Electrical characteristics
Type
ELC X24-210
ELC X24F-210
ELC X24B-210
ELC X24i-210
Nominal supply voltage
400 V - 480 V
440 V
400 V - 480 V
Operating supply voltage range
400 V - 480 V
Nominal supply current
32 A – 27 A per module
29 A per module
32 A – 27 A per module
Max. supply current
36 A per module
Line protection*
min. 40 A per module
Internal fuse at mains input
(F200, F203)
SIBA 5012434.40 URZ 40 A / 690 V / 14x51 mm or comparable type
class gRL (gS)
Arcing-I²t-Value 420 A²s, Total I²t-Value (@AC 690 V) 3100 A²s
Mains frequency
50 / 60 Hz
Min. mains voltage (shut down
voltage)
320 V
Output power reduction in case
of low mains voltage (also see
paragraph 3.4.4)
from approx.
360 V – 320 V:
50 W / V
from approx.
360 V - 320 V @ 45°C,
400 V - 320 V @ 55°C:
50 W / V
from approx.
360 V – 320 V:
50 W / V
Abs. max. mains voltage
528 V
Leakage current
ca. 10 mA per module
Insulation resistance between
primary and PE
> 30 MΩ
Discharching time of residual
voltage after mains
disconnection
according to label above mains connector in the ballast
Charge time (minimum time
between switch on of the ELC
and starting the lamp)
16 s
*Line protection: automatic cut-out characteristic C