Etec 32E40 - Connection to a Personal Computer

32E40-17
Installation
Connection to a Personal Computer
Connecting a PC or laptop
Connecting to an amplifer or home theater system
Recommended computer display resolution:1366x768@60 Hz
How to Connect a PC
• Connect using a male to male VGA cable (not included) from your PC to
the “VGA” on the TV’s rear panel.
How to Connect Audio Sound
• Connect a 3.5mm audio cable (not included) from the computer’s mini
audio output jack to the audio input on the TV’s rear panel.
How to Use
• Press the INPUT button on the remote control. Use the buttons  to
highlight PC. Press ENTER.
NOTE: If your PC uses a standard signal mode, the screen will adjust
automatically.
VGA & Audio Cable (not included)
TV REAR PANEL
TV REAR PANEL
Audio Amplier
Audio Cable (not included)
How to Connect to an amplier / surround sound system
• Match and insert the red and white audio cables from “Line Out”
on the TV to “Line In” on your amplier.
NOTE: The TV’s speakers will still output audio. You can turn the
TV’s speaker volume to 0 to prevent echoing.
VGAHDMI3HDMI2HDMI1
RF
PC AUDIO
COAXIAL OUT
Input Source
USB
VGA
HDMI1
HDMI2
HDMI3
V L R Y Pb Pr L R
AV
YPBPR AUDIO OUT