Generator G11 16
Generator G11 Operator’s Manual
Touch the back arrow or close button after adjusting the settings to exit�
Language
Select the preferred language from the options in the ‘Language’ screen� There are multiple language options, English being the default� Once
the user selects and confirms the selection of a new language that language becomes the new system default�
Touch the desired option, a confirmation screen will appear�
Select ‘OK’ to confirm the language selection or ‘Cancel’ to cancel the language change�
Extended Activation
Some ENSEAL instruments allow the ability for use in Extended Activation Mode� When this option is selected, the Extended Activation
ON/OFF screen will appear, allowing the user to select the Extended Activation ON or Extended Activation OFF options� When this mode is
enabled and the instrument is being activated, the generator will deliver energy for as long as 2 minutes� Tone 3 (Cycle Complete) will not be
received during an activation cycle while this mode is enabled� Energy delivery can be terminated at any moment by releasing the footswitch
or hand activation button� If the instrument is unplugged or the generator is powered down while ‘Extended Activation ON’ is selected the
generator will revert to the system default setting of ‘Extended Activation OFF’� This feature is grayed out when not available for some EN-
SEAL instruments�
System Information
Select ‘System Information’ to see high-level information about the generator and the instrument currently connected to the generator� The
screen will also allow determination of the currently installed generator software revision�
Biomed Information
‘Biomed Information’ allows the technicians to access information about each error that has occurred on the generator� Touch the back arrow
or close button to exit�
To Next Page
Loading...
