27971-01A
Installation - Remote Connections
Parameter Function
2 Flip Indicator (timer beeps halfway through session) default - off
5 Session Count (adjustable)
6 Lamp Hours (adjustable)
7 Bed Hours
8 Manual Sessions (counts sessions in “stand-alone” mode)
9 Clean Bed Indicator - 0 = off, 1 = on
10 Manual Lockout (unit only works with T-max® remote) default - off
13 Cooldown Time (length of time fans run after session) default - 5 minutes
15 Master Session Count (not adjustable)
23 Auto Resume (unit continues session after power outage) default - off
38 Face Tanner Lockout Time (seconds face tanner cools before turning on again) default - 60
255 Reset Factory Defaults
T-Max® Parameter Chart
Setting the address manually
Before connecting your booth to the T-
Max® Manager or T-Max® 1A or 3A, the
address of your booth must first be set. Set
the “id” manually as described below.
Setting the Address
1. Make sure the bed display is show-
ing “0:00”.
2. Press the STOP button for three sec-
onds. The display should indicate an
address number from “1” to “255”.
3. If you are using a T-Max® 1A or 3A
as a “master” remote, the address of
the bed must be set to “1”. If you are
using a T-Max® Manager each
sunbed must be assigned a different
address. To adjust the address, press
the START button to count up until
the desired number (from 1 to 128)
is achieved. Addresses 252 to 255
are not normally used.
4. Press the STOP button to return to
the normal display mode.
27
To Next Page
Loading...
