27971-01A
1
nstallation
Pre-Installation Planning
Before you begin to assemble your sunbed, you should observe the following consid-
erations.
• The SolarForce® 648 operates from
a 220V AC power source. The unit
should be wired to a dedicated cir-
cuit capable of providing 80 Amp
service. This unit must be hardwired
directly to a junction box. W
e rec-
ommend connection by a profes-
sional electrician.
• IMPORTANT! Voltage must be
below 230V AC or may require a
Buck Booster.
WARNING
Shock hazard.
Disconnect power before
servicing.
Air from the room is used to cool
the sunbed. Maximum ambient
room temperature should be 80°F.
Place your sunbed no closer than
6” from any wall. Make sure nothing
obstructs the airflow into or out of
the fan openings. A poorly ventilat-
ed room may cause the unit to
become hot and cause discomfort
to the user.
CAUTION
Use of a voltage source above 230V
AC may prevent proper operation of
the sunbed and could cause damage
and void the warranty.
CAUTION
Proper assembly of your sunbed
requires three people. Plan to have
a couple of helpers assist you.
CAUTION
To Next Page
Loading...
