27971-01A
39
Troubleshooting
Problem Solution
My bed, connected to a T-Max®
Manager, did not display “dL” but
does indicate:
- “0:00”
- a tanning time and the lamps
have come on
- a tanning time but the lamps
have not come on
When auto-addressing the first
bed does not register an address
1. Remote device has not been set.
2. The sunbed has not been connected to the remote system, see
Remote Connections.
1. Delay time of T-Max® Manager has not been set.
2. Delay time has expired and session has begun.
Auto start function of T-Max® Manager has been turned off.
Press the START button to turn on lamps.
When using the auto address feature of the T-Max® Manager
you must wait 10 seconds from the time you start the auto
address function before addressing the first bed.
To Next Page
Loading...
