19
27330-01A
Operation - Using Your Sunbed
1. Lift canopy, lie down on bench (face up),
lower canopy toward your body using
canopy handle. Maintain at least 3”
between your body and the canopy and
rear lamp module acrylics.
2. Put on your safety goggles.
3. Assuming the remote system has been set
to allow a pre-tanning delay time, the timer
display (E) will repeatedly flash the delay
symbol “dL” and then the remaining delay
time. Press the timer button (G) or wait
until the delay time has expired to begin
the tanning session. The lamps will turn on
and the timer will begin to count down.
4. When the timer reaches 0 the lamps turn off.
If you want to interrupt your session before
time expires, press the stop button (F).
5. Raise the canopy by using the canopy
handle, do not push up on the acrylic
shield. The cooling fans run for a period of
time after the lamps shut off to aid in cool-
ing the sunbed. The timer will indicate “..”
as a reminder to clean the sunbed. After
the sunbed is cleaned press the timer but-
ton and the display will return to “0”.
Using Your Sunbed
When connected to the T-Max® Manager or T-Max® 1A or 3A.
A Face tanner control - Turns face tanners
on and off during use. Face tanner
lamps require one minute to relight.
B Shoulder tanner control - Turns shoul-
der lamps on and off during use.
C Body fan control - Controls the speed of
the body fan during use. (At your feet)
D Body fan speed indicator - Indicates
speed of fan. (OFF - LOW - MED -
HIGH)
E Timer display - Displays remaining time.
F Stop button - Interrupts tanning session.
G Timer button - Turns bed on. Timer dis-
play shows remaining time.
AB CDEF G
WARNING
Wear protective eyewear.
Failure to may result in severe burns or
longterm injury to the eyes.
To Next Page
Loading...
