27330-01A
21
Care and Maintenance
Cleaning After Use
Clean and disinfect your tanning bed’s
bench, canopy and rear lamp module after
each use. Use a non-abrasive disinfectant
cleaner that does not contain ammonia or
ammonia derivatives. Ammonia may dam-
age the acrylic shield. Spray the acrylic
lightly with disinfectant and wipe dry with a
clean soft cloth. We recommend Australian
Gold® pH Neutral Disinfectant Cleaner.
Thorough Periodic Cleaning
Introduction
The cooling fans draw air through the bed
and over time will cause a dust buildup on
the lamps and reflectors. This will reduce
the tanning effectiveness of the bed. When
a dust buildup is observed, it is necessary to
thoroughly clean the inside of the unit.
Cleaning the Canopy and Bench
Step 1 Remove the acrylic shields and
lamps as described in Lamp and
Acrylic Replacement.
Step 2 With a soft cloth, wipe the entire
length of each lamp.
Step 3 Clean both sides of the acrylic
shields with a non-ammonia dis-
infectant cleaner.
Step 4 Wipe the reflectors with a clean
damp cloth.
Step 5 Reinstall the lamps and acrylic
shields.
Step 6 Clean or replace air filters on top
of ballast tray and under bench
(see Final Adjustments). Replace
with 10” x 24” x 1” furnace filters.
Mechanical Inspection
Your tanning bed has been built for years of
service. To ensure trouble-free operation
throughout its life, inspect the unit’s
mechanical integrity every 400-500 hours
of use.
• Inspect the unit’s fasteners verifying
that all are firmly in place.
• Inspect lift adjustment. Adjust for prop-
er lift if needed. See Final Adjustments.
• Inspect the AC power cord and its
connections.
• Inspect the acrylic. Broken, cracked
or
badly scratched acrylics should be
immediately replaced.
• Check damper operation. The
damper limits the canopy’s move-
ment speed. Replace if canopy raises
and lowers too quickly.
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.
To Next Page
Loading...
