2
Installation - Pre-Installation Planning
27330-01A
Pre-Installation Planning
Before you begin to assemble your
sunbed, you should observe the following
considerations.
WARNING
Shock hazard.
Disconnect power before
servicing.
Air from the room is used to cool the
sunbed. Maximum ambient room tem-
perature should be 80°F. Place your
sunbed no closer than 6” from any wall.
Make sure nothing obstructs the airflow
into or out of the fan openings. A poorly
ventilated room may cause the unit to
become hot and cause discomfort to
the user.
CAUTION
Use of a voltage source above 230V AC
may prevent proper operation of the
sunbed and could cause damage and
void the warranty.
CAUTION
Proper assembly of your sunbed
requires four people. Plan to have a
few helpers assist you.
CAUTION
• The STARPOWER® 548 operates from a
220V AC power source. The unit should
be wired to a dedicated circuit capable
of providing 60 Amp service. This unit
must be hardwired directly to a junction
box. W
e recommend connection b
y a
professional electrician.
• IMPORTANT! Voltage must be below
230V AC or may require a Buck Booster.
Hardware Inventory
Open the hardware bags and remove the
hardware. In addition to a pillow, an RJ-
11 (phone type) cable and touch-up paint,
make sure you have the following hard-
ware items.
#10 x 1” Phillips
Pan Head Screw
Quantity 14
3/8-16 x 1 1/4”
Hex Socket Bolt
Quantity 18
3/8-16 Self-locking
Hex Nut
Quantity 18
#10 x 1/2” Phillips
Pan Head Screw
Quantity 12
To Next Page
Loading...
