15
Operation and Maintenance Instructions
Drift Eliminators
Induced Draft Units (AT, USS, and UT Models)
Orientation of the eliminator sections on induced draft units is not critical. Note though, that the eliminator sections must fit tightly
together within the fan section of the unit.
Forced Draft Units (LSTB, LPT and LSTA Models)
The eliminator sections are constructed of PVC and are not designed to support the weight of a person or to be used as a work
surface for any equipment or tools. Use of these eliminators as a walking surface or working platform may result in injury to
personnel or damage to the equipment.
Figure 12 – Drift Eliminators Figure 13 – Drift Eliminator Orientation on LPT units
Figure 14 – Drift Eliminator Orientation on LSTA units Figure 15 – Drift Eliminator Orientation on LSTB units
To Next Page
Loading...