EVBox Elvi - Pairing; Configure the Installer Mode Settings

4.6.3. Pairing
Note:
Pairing is only applicable to a Hub charging station.
1. Switch on electrical power to Elvi.
Elvi powers up and runs the start-up sequence.
Bluetooth is now activated.
2. Open the EVBox Connect app on your smartphone or tablet, then select START PAIRING in the
app.
3. Select the Chargepoint ID of Elvi, then select PAIR. The LED ring on Elvi flashes purple during
pairing (Bluetooth is active).
4. Confirm the Chargepoint ID of Elvi.
5. Enter the security code.
The app configuration menu opens.
You can now configure the charging station.
4.6.4. Con@gure the installer mode settings
The installer mode settings must be configured before the charging station is activated.
WARNING:
Risk of electric shock, which can cause severe injuries or death. Only a qualified electrician is
permitted to access the installer mode.
1. Make sure that your smartphone or tablet is paired with the charging station.
2. In the EVBox Connect app, select Installer mode and then enter the security code.
3. Select Charge current, then set the minimum and maximum charging current.
DANGER:
The maximum charging current setting must match the capacity of the power supply.
EN
4. Installation instructions
22