4. Select Set Charger to Online to be online or offline.
For a charging station set to offline:
• The charging cards and key fobs which are added to the EVBox Connect app are used to start
and stop a charge session.
For a charging station set to online:
• A charging session uses the Charging Management Platform.
• The charging cards and key fobs used must be registered with the Charging Management
Platform to be able to start and stop a charging session.
5. Select Charging Management Platform, then select a platform from the list.
6. While paired, you can also configure the user settings for the charging station. See Configure the
user settings on page 23.
7. Reboot your charging station to save the settings.
The settings are saved and the charging station reboots.
4.6.5. Con@gure the user settings
Note:
A qualified electrician must first configure the installer settings before the user can set the user
settings.
Note:
The user settings configured for a Hub charging station are also applied to Satellite charging
stations in the same installation.
1. Make sure that your smartphone or tablet is paired with the charging station.
2. In the EVBox Connect app, select Charging Station Setting then select Wi-Fi Connection.
Connect the charging station to your local Wi-Fi connection.
3. Select Cards and add a charge card or key fob to use every time you start charging.
4. Select Charger Access Control and set how you want to start a charge session:
For a charging station set to offline:
• Activate using card/key fob: the charging cards and key fobs which are saved in the EVBox
Connect app are used to start and stop a charge session
• Autostart: the charging session starts and stops when the charging cable is connected and
disconnected.
For a charging station set to online:
• Activate using card/key fob: the charging card/key fob used will authenticate the session on
the Charging Management Platform.
• Autostart: the charging card or key fob which is saved and selected in the EVBox Connect
app will authenticate the session on the Charging Management Platform.
5. If required, select LED settings and set the brightness of the LED ring.
6. Select reset.
The settings are saved and the charging station reboots.
4. Installation instructions
EN
23
To Next Page
Loading...
