24 25
Installation with Vehicle Seat Belt
4.
Buckle seat belt
.
Installation with Vehicle Seat Belt
5. Remove all slack
from the seat belt.
Using your full weight,
push the child restraint
firmly into the vehicle
seat
while tightening
the
seat belt to remove
excess slack.
Locking Clip
installed properly
13 mm
(0.5 in.)
If your vehicle is model year 1996 or newer, it likely
has a vehicle belt system that can be locked when
tightened, and will not require use of a Locking Clip.
Consult your vehicle owner’s manual before installing
a locking clip.
If your vehicle requires a Locking Clip, please call
ParentLink at 1-800-233-5921 (U.S.) or 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico) to obtain a
Locking Clip and instructions on how to install and use it.
6. Install Locking Clip
(not included), if
necessary.
If your vehicle was
built prior to model
year 1996, and has
a lap/shoulder belt
that is equipped with
an emergency locking
retractor (ELR) AND
sliding latch plate, you
MUST use a Locking
Clip. Check your vehicle
owner’s manual to
identify which vehicle belt
system is in your vehicle.
WARNING
• Remove Locking Clip from vehicle seat belt when not
used with a child restraint, or the vehicle seat belt will not
properly restrain an adult or child. Serious injury could occur.
• DO NOT use a Locking Clip in booster mode.
With 5-Point Harness
7. Ensure child
restraint is secure.
Hold the child restraint
near the upper belt path,
as shown, and try to
move it in all directions.
Upper Belt
Path
IMPORTANT: To properly secure this child restraint, it
MUST NOT move more than 25 mm (1 inch) from side to
side or from front to back at the upper belt path. If you
can not tightly secure the child restraint, try again or move
it to another location.
8.
Connect and tighten
Tether Strap.
Connect the Tether Hook to the Anchor behind the
vehicle seat, as shown. (Please consult your vehicle
owner’s manual, as Tether Anchor locations may
vary.) Pull the strap and tighten the Tether securely.
Note: The installed seat should be positioned as shown
above.
IMPORTANT:
• The Tether Strap MUST be used when installing this
child restraint with the vehicle seat belt, if a tether
anchor is available.
• If your Tether Strap is too short to reach your vehicle
Tether Anchor, you will need a Tether Extender. Please
call ParentLink at 1-800-233-5921 (U.S.) or
1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico).
To Next Page
Loading...
