Evenflo Evolve - Removing the Backrest; Using the Shoulder Belt Clip; Attach No-Back Booster Insert (Canada ONLY)

44 45
1. Lay the booster seat on its back.
Remove crotch strap to make removing the backrest
easier (p. 49).
2. Push release lever to remove backrest.
Use your thumb to push the release lever
A
on the
bottom of the base
B
, as shown, then slide the base
off of the backrest
C
.
Note: Once backrest is removed, store crotch strap in
bottom of base (p. 40).
Removing the Backrest
RECLINE
.
RECLINE
IMPORTANT
Store the backrest properly when not in use and do not leave in
the vehicle (other than in trunk). Any loose objects can become
projectiles and injure someone during a crash.
B
Using the Shoulder Belt Clip
For Canadian Models ONLY
2. Attach no-back booster insert.
Slide no-back booster insert
D
into back of base
B
until it snaps into place, as shown.
Note: If you are using the shoulder belt clip, make sure the
strap is pulled tight before attaching the no-back booster
insert.
1. Attach shoulder belt clip as shown.
A
B
B
C
Booster Without Backrest
A
WARNING
• DO NOT use the recline stand in booster mode.
The recline stand can only be used with the 5-point
harness.
D
B
Autogoods “130”
130.com.ua