42 43
1. Remove the backrest from the booster seat.
See “Removing the Backrest”, (p. 44.)
2. Place the booster seat on the vehicle seat.
Make sure the booster seat is in the upright position,
(p. 52).
3. Set the child in the booster seat.
Make sure the child’s back is flat against the vehicle
seat and the child’s bottom is flat against the booster
seat.
4.
Secure the child and booster seat to the vehicle seat.
Stretch the lap/shoulder belt across the child and
fasten the buckle.
5. Use the shoulder belt clip, if necessary.
If the shoulder belt does not properly lay midway
between the child’s shoulder and neck, attach and
adjust the belt clip. See “Using the Shoulder Belt
Clip”, (p. 45).
6. Check your work.
Make sure the lap belt is stretched low and snug
across the child’s hips, beneath the belt guides, and
fastened into the buckle. The shoulder belt must cross
the child midway between his/her shoulder and neck.
Note: If the vehicle’s shoulder belt naturally crosses the
child’s shoulder, you do not need to use the shoulder
belt clip.
The shoulder belt MUST NOT cross the child’s neck or fall off
the child’s shoulder. If you cannot adjust the shoulder belt to
properly lay midway between the child’s shoulder and neck,
try another seating location or do not use the booster seat.
Child Requirements
Weight: 18 to 54.4 kg (40 to 120 lbs)
Height: 112 to 145 cm (44 to 57 inches)
AND the tops of the child’s ears are
at,
or below, the top of vehicle seat headrest.
Age: At least four years old
IMPORTANT
Always secure the booster seat with the vehicle seat belts
when not occupied. An unsecured booster seat can fly into
and injure other occupants in the event of a crash.
WARNING
Installation Checklist
Using Your Booster Seat
Without the Backrest
The shoulder belt MUST
cross midway between
child’s shoulder and neck.
Use shoulder belt clip, if
necessary.
The lap belt is stretched low
and snug across the child’s
hips, beneath the belt guides,
and fastened into the buckle.
Booster Without Backrest
Shoulder
Belt Clip