22 23
Installation with Quick Connectors
5.
Connect and tighten
Tether Strap.
Connect the Tether Hook to the Anchor behind the
vehicle seat, as shown. (Please consult your vehicle
owner’s manual, as Tether Anchor locations may
vary.) Pull the strap and tighten the Tether securely.
Note: The installed seat should be positioned as shown
above.
With 5-Point Harness
Installation with Vehicle Seat Belt
Upper
Belt Path
1. Disconnect Tether
Hook from the
back of the child
restraint.
IMPORTANT:
• If the child weighs more than 20.4 kg (45 lbs), install
this child restraint with the vehicle seat belt (NOT
Lower Anchors).
• Before installing this child restraint with the vehicle
seat belt, you MUST make sure the Lower Anchor Hooks
or Quick Connectors are attached to the storage hooks on
the back of the child restraint.
• Check your vehicle owner’s manual to determine how to
lock your seat belt for child restraint installation. The seat
belt must be locked to properly secure the child restraint.
• When using the vehicle seat belt to secure the child
restraint, DO NOT use the Lower Anchors. Using both
together can cause slack in a sudden stop or crash.
2. Place the child
restraint in
position.
Set child restraint on
vehicle seat in forward-
facing position. ALWAYS
make sure bottom of
child restraint sits flat on
vehicle seat and posi-
tioned, as shown. Lay
the Tether Strap over the
back of the vehicle seat.
Tether Strap
3.
Route seat belt
through upper
belt path
.
Route the seat belt buckle
tongue through the upper
belt path, as shown.
IMPORTANT:
• The Tether Strap MUST be used when installing this
child restraint with the Quick Connectors.
• If your Tether Strap is too short to reach your vehicle
Tether Anchor, you will need a Tether Extender. Please
call ParentLink at 1-800-233-5921
(U.S.) or
1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico).
To Next Page
Loading...
