storage
3. Fasten the aircraft seat belt, then remove
all slack from the belt.
The aircraft seat belt must be as tight as possible.
Route the excess aircraft seat belt strap back through
the belt path opening. Using your full weight, push
the child restraint firmly onto the aircraft seat while
pulling on the excess seat belt strap to tighten.
Note: Because of the fixed length of aircraft seat belts, the
belt buckle could be behind the child’s back after tightening
the belt. For your child’s comfort, Evenflo recommends
cushioning the child’s back by placing a small pillow or
folded-up blanket or jacket, over the belt buckle.
Check your work: Reconnect the seat pad to the child
restraint. Try to move the child restraint in all directions.
If you can move the restraint more than 25 mm (1 inch)
from side to side or front to back at the upper belt
path, the aircraft seat belt is not tight enough, and you
MUST install again until the seat belt is tight.
General
Installing Child Restraint in Aircraft - cont.
Not available on all models. Styles may vary.
You can order replacement parts on-line at www.evenflo.com
or contact ParentLink at 1-800-233-5921. When you contact
us, please have the product model number and date of
manufacture (found on the bottom of the child restraint).
Replacement Parts
Seat Pad
To Next Page
Loading...
