4. Secure the child
restraint.
Using your full weight,
push the child restraint
firmly into the vehicle seat
while pulling up on the
LATCH strap to tighten.
Rear-facing Belt Path
IMPORTANT: To properly secure this child restraint, it
MUST NOT move more than 25 mm (1 inch) from side-to-
side or from front-to-back at the rear-facing belt path.
If you cannot tightly secure the child restraint, try again or
move it to another location.
3. Increase recline
angle, if necessary.
If level line is not parallel
to the ground, disconnect
Quick Connectors and
place a tightly rolled
towel/small blanket
beneath the front edge
of the child restraint.
Repeat Step 2.
Tightly rolled towel
or small blanket
IMPORTANT: Infants may have difficulty breathing when
in a sitting position. Make sure they recline enough for their
head to lie back comfortably and safely. Failure to properly
recline the child restraint could increase the child’s risk
of serious injury or death.
Level Line
Rear-facing Installation with Quick
Connectors
27
Rear-facing
To Next Page
Loading...
