Evenflo Symphony 65 - Rear-Facing Installation with the Seat Belt

28
1. Place the child
restraint in position.
Adjust the child restraint
to the most reclined
position (Recline Position
#1, p. 62), then place it on
vehicle seat in the rear-
facing position, as shown.
2. Route seat belt through rear-facing belt
path . Unhook the front of the seat pad and move
it out of the way. Thread the vehicle seat belt buckle
tongue through the rear-facing belt path, as shown.
IMPORTANT: Make sure the buckle/crotch strap is positioned
in front of the vehicle seat belt (p. 12).
Rear-facing Installation with the Seat Belt
IMPORTANT:
•IfyouareusingtheLATCHsystemtosecurethechild
restraint, DO NOT use vehicle seat belt.
•Before installing this child restraint rear-facing with the
vehicle seat belt, you MUST move the LATCH assembly
to the forward-facing belt path so that is does not inter-
fere with the vehicle seat belt.
•If your child restraint has SureLatch connectors, refer to
page 34. If your child restraint has Quick Connectors,
refer to page 40. Also, make sure the SureLatch or Quick
Connectors are attached to the storage D-rings on the
seat pad.
•DO NOT use the tether strap when the child restraint is
in the rear-facing position.
Lap Belt Only
Lap and Shoulder
Belt Combination