Evenflo Symphony 65 - Rear-Facing Installation with Surelatch Connectors

22
1. Place the child
restraint in position.
Adjust the child restraint
to the most reclined
position (Recline Position
#1, p. 62), then place it on
vehicle seat in the rear-
facing position, as shown.
2. Attach SureLatch Connectors.
Push a SureLatch connector onto each seat anchor.
Note: You may need to vary the angle of the SureLatch
connectors, as shown above, to attach to the anchor.
Also, make sure the SureLatch assembly is in the rear-
facing belt path (p. 20).
Far side
LATCH Anchor
LATCH Anchor
Near Side
IMPORTANT: Make sure both
SureLatch connectors are
facing upward and the straps
are not twisted.
Strap
IMPORTANT:
•Ifyouareusingthevehicleseatbelttosecurethechild
restraint, DO NOT use the LATCH system.
•DO NOT use the tether strap when the child restraint is
in the rear-facing position.
Rear-facing Installation with SureLatch
Connectors