Evenflo Symphony 65 - Forward-Facing Installation with the Seat Belt

OWNER’S MANUAL
Keep
for future use.
Symphony
™
Child Restraint System
Forward-facing Installation with Seat Belt
1. Disconnect tether
hook from the back
of the child restraint.
IMPORTANT:
•If you are using the LATCH system to secure the child
restraint, DO NOT use the vehicle seat belt.
•Before installing this child restraint forward-facing with
the vehicle seat belt, you MUST move the LATCH as-
sembly to the rear-facing belt path so that it does not
interfere with the vehicle seat belt.
•If your child restraint has SureLatch connectors, refer to
page 20. If your child restraint has Quick Connectors,
refer to page 24. Also, make sure the SureLatch or Quick
Connectors are attached to the storage D-rings on the
seat pad.
2. Place the child
restraint in position.
Make sure child restraint
is in Recline Position #2
or #3 (p. 62).
Set child restraint on
vehicle seat in forward-
facing position, as
shown. Lay the tether
strap over the back of
the vehicle seat.
Tether Strap
IMPORTANT: NEVER use Recline Position #1 for forward-
facing, AND NEVER use Recline Position #2 with children
who weigh more than 18 kg (40 lbs).
45
Forward-facing