5. Connect and tighten
tether strap.
Connect the tether hook
to the anchor behind the
vehicle seat, as shown.
Pull the strap and tighten
the tether securely.
4. Secure the child
restraint.
Using your full weight,
push the child restraint
firmly into the vehicle seat
while pulling up on the
LATCH strap to tighten.
Forward-facing
Belt Path
Forward-facing Installation with
Quick Connnectors
44
Notice
Your child restraint is equipped with one of two types of tether
adjusters: standard (shown above) or the TruTether (shown
below). If your child restraint is equipped with the TruTether ad-
juster, refer to page 63 for information about proper tightening.
TruTether Adjuster
Tightness Indicator
Display
IMPORTANT: If your tether strap is too short to reach from
your child restraint to your vehicle tether anchor, you will
need a Tether Extender. Please call ParentLink.
IMPORTANT: To properly secure
this child restraint, it MUST
NOT move more than 25 mm
(1 inch) from side-to-side or
from front-to-back at the forward-facing belt path.
If you cannot tightly secure the child restraint, try again or
move it to another location.
To Next Page
Loading...
