Evenheat Set-Pro - Metal Clay Express Mode Firing Data

Set-Pro Control Operating Manual
Metal Clay version – Nov. 2014
Page 10 of 21
Use your Smart-phone to scan this QR code to watch Set-Pro how-to Programming Videos!
Metal Clay Express Mode Programming (Detailed) – continued from previous page
If you chose to fire using the Prometheus Clay presets you will see the 2 Prometheus Clay material choices:
COP2 = Prometheus Clay Copper
bron = Prometheus Clay Bronze
9. Use the Up and Down arrows to select and match the appropriate Metal Adventures, Art Clay, PMC or Prometheus Clay preset firing program with the
metal clay you intend to fire.
10. Press the Enter key. The display will read °F along with the preset final temperature the kiln will reach during the firing.
This is the temperature where your metal clay matures. We call it final temperature. You do have the option at this point of adjusting the final
temperature for this program if you desire. Use the Up and Down arrow keys to adjust. If you are new to metal clay firing we would suggest that
you do not adjust the final temperature at this point. Wait until you get a feel for the material and firing characteristics before making changes.
11. Press the Enter key. The display will read HLd1 along with the preset hold time at final temperature.
Hold time is the amount of time the firing will hold or soak at final temperature. You do have the option of adjusting the hold time for this
program if you desire. Use the Up and Down arrow keys to adjust. If you are new to metal clay firing we would suggest that you do not adjust
the final temperature at this point. Wait until you get a feel for the material and firing characteristics before making changes.
12. Press the Enter key. The display will read rEdI which stands for Ready.
13. Press the Enter key to begin the firing. The Set-Pro is now running your selected metal clay program.
When the firing is complete the display alternates between CPLt along with total firing time. Pressing the Start/Stop key at this point will cause the display
to briefly read StOP and then IdLE.
You may stop the firing at any time by pressing the Enter key. Doing so will cause the firing to stop and StOP will briefly be displayed.
Metal Clay Express Mode Firing Data
The Metal Clay Express Mode uses preset firing data to fire your metal clay. You will find the actual, preset firing data used in the Metal Clay Express Mode
programs can be found on page 20 of this manual.