Set-Pro Control Operating Manual
Metal Clay version – Nov. 2014
Page 17 of 21
Use your Smart-phone to scan this QR code to watch Set-Pro how-to Programming Videos!
Programming and Use Features Continued from Previous Page
Number of Segments
The Set-Pro can control up to 8 segments per Custom program. However, that doesn’t mean that you need to use all 8. If your program only needs 1 or 2
segments to operate, great, use only 1 or 2. When it comes time to choose just select the number of segments you need.
Writing Over Data
You will want to change the data in your Custom Mode programs at some point. We expect this as you try new techniques and fine tune your skills. When
you do, you’ll see the old firing data as you’re programming in the new data. Simply key in the new data as though the old never existed.
Clearing Function
There is no feature that allows you to perform an “ALL CLEAR” function, i.e. set all the settings to 0. Sorry. We understand the desire for such a feature but
it’s really not necessary.
Fahrenheit or Celsius
Your Set-Pro was set at the factory for use in the Fahrenheit or Celsius temperatures scales. If programmed to the Fahrenheit scale you will see °F when
programming your set point temperatures. If set to Celsius you will see °C when programming your set point temperature. You will also note that a small,
red dot will be illuminated at the bottom right of the Set-Pro display area to indicate a Celsius temperature. This small, red dot is not illuminated when
using the Fahrenheit scale. If you would like to change which temperature scale you are using please consult Evenheat if you wish to adjust this setting.
Maximum Programmable Temperature
Depending upon your kiln model, the maximum temperature that can be programmed in the Set-Pro is either 1700°F (927°C) or 2000°F (1093°C). These
maximums are factory set. In some circumstances these maximums can be set higher. Please consult Evenheat if you wish to adjust this setting.
Firing Down to Room Temperature
Over the years we’ve seen users attempt to program their Custom programs to come down to room temperature at the end of the firing. They have
literally programmed in 72° as the last segment temperature. Don’t do this. If your actual room temperature goes above what you have programmed the
firing won’t end until the room temp drops, you get an error or you stop the firing. If you want to control the cooling down to some low, final temperature
don’t make it room temperature. We suggest 200° or above.
Delay Start Feature
The Set-Pro can delay the start of your firing for up to 100 hours. This feature becomes valuable when different electrical rates are charged at different
times of the day.
To Use the Delay Start feature
With the display reading rEdI press the DOWN arrow key one time. dELA is displayed. Use the UP and DOWN arrow keys to select the amount
of delay start time. Press the Enter key. The display will read rEdI. Press the Start/Stop key one time. The Set-Pro will display dLY along with
remaining delay start time. When the delay start counts down to 0 the firing program will start.
To stop the delay start feature press the Start/Stop one time.
To Next Page
Loading...
