5 For Professional Technical Support call 1-844-241-5521
1
Priming water
2
Attaching the suction hose to
strainer
Add water (approximately 1-2 Tbsp.) into the inlet to wet the
impeller of the pump (A).
Attach the clear suction hose (C) to the suction strainer (B) by
pushing the male threaded end into the rubber coupler on the
suction strainer.
Then, place the strainer in at least 1/2 in. of water at the lowest
point to be pumped.
NOTE: Make sure the connection is airtight. An air
leak can cause the pump (A) to run dry.
3
Attaching the suction hose to the
pump inlet
4
Attaching the discharge hose to
the pump outlet
Thread the other end of the suction hose (C) to the suction inlet
of the pump (A).
Make sure the suction hose (C) and suction strainer (B) are in
the water before plugging in the pump (A).
NOTE: Always ensure the washer in the hose bib is
not damaged. An airtight seal is necessary for this
pump to operate.
Thread a 5/8 in. or larger garden hose (sold separately, 50 ft.
max. length) onto the discharge outlet of the pump (A).
NOTE: Make sure the end of the outlet hose is not
under water. If the outlet is under water, the pump
may not work.
To Next Page
Loading...
Need help?
General
