EasyManuals Logo

Everbilt ZE00802A Use And Care Guide

Everbilt ZE00802A
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2 For Professional Technical Support call 1-844-241-5521
Table of Contents
Table of Contents .......................................................... 2
Performance .................................................................. 2
Safety Information ......................................................... 2
Warranty ......................................................................... 3
Pre-Installation .............................................................. 4
Installation ..................................................................... 5
Care and Cleaning ........................................................ 7
Troubleshooting ............................................................ 8
Performance
SKU HP
GPH of Water @ Total Feet Of Lift
Max. Lift
0 ft. 10 ft. 20 ft. 30 ft. 40 ft.
1001093976 1/10 360 318 264 198 132 42 ft.
Safety Information
DANGER: Do not pump flammable or explosive liquids
such as oil, gasoline, kerosene, ethanol, etc. Do not use in
the presence of flammable or explosive vapors. Using this
pump with or near flammable liquids can cause an
explosion or fire, resulting in property damage, serious
personal injury, and/or death.
DANGER: ALWAYS disconnect the power to the pump
before servicing.
DANGER: Do not touch the motor housing during
operation. The motor is designed to operate at high
temperatures. Do not disassemble the motor housing.
DANGER: Do not handle the pump or pump motor with
wet hands or when standing on a wet or damp surface, or
in water before disconnecting the power.
WARNING: Release all pressure and drain all water
from the system before servicing any component.
WARNING: Secure the discharge line before starting the
pump. An unsecured discharge line will whip, possibly
causing personal injury, and/or property damage.
WARNING: Extension cords may not deliver sufficient
voltage to the pump motor. Extension cords present a life
threatening safety hazard if the insulation becomes
damaged or the connection ends fall into water. We
recommend the pump be plugged directly into an outlet.
WARNING: Wear safety goggles at all times when
working with pumps.
WARNING: This unit is designed only for use on 115
volts (single phase),60 Hz, and is equipped with an
approved 3-conductor cord and 3-prong grounded plug. Do
not remove the ground pin under any circumstances. The
3-prong plug must be directly inserted into a properly
installed and grounded 3-prong, grounding-type
receptacle. Do not use this pump with a 2-prong wall
outlet. Replace the 2-prong outlet with a properly
grounded 3-prong receptacle (a GFCI outlet) installed in
accordance with the National Electrical Code and local
codes and ordinances. All wiring should be performed by a
qualified electrician.
WARNING: Protect the electrical cord from sharp
objects, hot surfaces, oil, and chemicals. Avoid kinking the
cord. Do not use damaged or worn cords.
WARNING: Failure to comply with the instruction and
designed operation of this unit may void the warranty.
ATTEMPTING TO USE ADAMAGED PUMP can result in
property damage, serious personal injury, and/or death.
WARNING: Ensure that the electrical circuit to the pump
is protected by a 5-amp minimum (15-amp max.) fuse or
circuit breaker.
CAUTION: Do not lift the pump by the power cord.

Other manuals for Everbilt ZE00802A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Everbilt ZE00802A and is the answer not in the manual?

Everbilt ZE00802A Specifications

General IconGeneral
BrandEverbilt
ModelZE00802A
CategoryWater Pump
LanguageEnglish

Related product manuals